Configuring The Wireless Lan Settings For Infrastructure Mode - Ricoh PJ WX4152NI Operating Instructions Manual

5. Using the Projector via a Network
1. Select [Wired LAN] on Network Setting Wizard, and then press the [Enter] button.
2. Select [Disable DHCP (Manual Settings)] or [Enable DHCP (Auto Settings)], and then press
the [Enter] button.
If you select [Enable DHCP (Auto Settings)], proceed to Step 6.
3. Specify the projector's IP address.
4. Specify the subnet mask.
5. Specify the default gateway.
6. Select [Continue Wizard] or [End Wizard] on the confirmation screen, and then press the
[Enter] button.
To proceed to the wireless LAN settings, select [Continue Wizard]. For details about how to
configure the wireless LAN settings, see page 68 "Configuring the Wireless LAN Settings for
Infrastructure Mode", or page 71 "Configuring the Wireless LAN Settings for Ad Hoc Mode".
To end the network settings, select [End Wizard].
The wired LAN setup is complete.
To project the image from a computer, see page 73 "Projecting a Computer's Screen via a
Network".

Configuring the Wireless LAN Settings for Infrastructure Mode

Configuring the settings by Simple Wireless LAN Setup
The projector supports the following simple wireless LAN setup method. Contact your network
administrator for the available simple wireless LAN setup method in your network environment and the
information required for configuring network settings.
Setup Method
• Using push buttons
Press the projector and access point keys or buttons to get them to connect to each other and
register the settings.
68