Using The Valet Switch; Emergency Override; The Status Light - Excalibur RF-31-EDP Operation Manual

Using The Valet Switch

The valet switch is a push button built into the window mount antenna. It is used to perform emer-
gency override and system programming (see inside of back cover for programming).

emeRgeNCY OVeRRIDe

If you were to lose or break your controller, you'd need to perform an emergency override to disarm
the system. To do so, use the following steps:
STep 1 - Enter the vehicle (the alarm may sound)
STep 2 - Turn the ignition key to the "ON" position
STep 3 - Press the valet switch (located in the window-mount antenna) once
STep 4 - Turn the ignition "OFF".

The Status Light

The status lights, located in the window-mount antenna, provide a visual indication of the system's
status via GREEN (remote start status) and RED (alarm status) lights.
SeCURITY SYSTem STATUS (ReD LIgHT):
OFF: The system is unlocked and not performing any automatic functions.
FLASHINg SLOw: The system is locked and monitoring all entry points.
FLASHINg FAST: One of the automatic arming features is in progress.
AUTOmATIC TRANSmITTeR VeRIFICATION (ReD LIgHT):
Every time you turn on the ignition key, the status light will flash a number of times equal to the num-
ber of controllers/transmitters programmed to the system. This unique security feature protects you
from a potential thief (valet attendant, mechanic, installer, etc.) adding their own transmitter without
and accessing your vehicle and it's contents at a later time (the perfect crime!).
10