When The System Triggers; Using The Valet Switch; Emergency Override; Valet Mode - Excalibur RS-360-EDP Operation Manual

Security System Features (cont'd)

whEN ThE SYSTEm TRIGGERS

If the system were to be compromised while armed, it will trigger sounding the
siren/horn and flashing the parking lights for 30 seconds (programmable). When
disarming the system after a trigger event, the siren/horn will chirp 4 times and the
parking lights will flash 4 times instead of the standard 2 times.
LOCK ON TRIGGER: If a door is opened when the system is triggered, it will wait
until the door is closed again, then lock the doors� This patented feature is useful to
further deny a thief of further access to the vehicle�
STORm SAFE mODE: When the system is triggered, pressing the "UNLOCK" button
will stop the alarm from sounding but will leave the doors locked� This function is use-
ful if you have a false triggering situation due to violent weather�
ZONE VIOLATION RECALL: The system is capable of telling you which zones were
triggered last. The system's status light will flash to indicate which zone was triggered.
This occurs during the alarm cycle AND after disarming� The system will store the last
triggered zone until the vehicle's ignition key is turned on� See "The Status Light" sec-
tion oon page 9 for further explanation of this feature�
NUISANCE PREVENTION: If the system prewarns 5 times within 15 minutes, it will
bypass the zone for the remainder of the 15 minutes before rearming the pre-warn
zone� Additionally, if a full trigger zone is left open, the system will trigger a total of 3
times before bypassing the zone� Once the zone is closed again, it will re-arm that
zone�

Using The Valet Switch

EmERGENCY OVERRIDE

If you lose or break your controller, you'll need to perform an emergency override to
disarm the system and use your vehicle� To do so, use the following steps:
STEP 1 - Enter the vehicle (the alarm should sound)�
STEP 2 - Turn the ignition key to the "ON" position�
STEP 3 - Press the valet switch (located on the window-mount antenna) once �
STEP 4 - Turn the ignition "OFF"�

VALET mODE

Valet mode completely disables all security & remote start functions� Keyless entry
is still operable� To enter valet mode, perform the following steps:
STEP 1 - Disarm the system by remote or by performing an emergency override�
STEP 2 - Press and hold the valet switch for 2 seconds� The system will chirp once
and the status light will turn on�
EXITING VALET mODE - Press and release the valet switch once� The status light
will turn off�
8