Window Mount Antenna Module; Status Lights; Valet / Programming Switch; Tach Programming - Excalibur AL-XX50-EDPB Installation Manual

Deluxe keyless entry, security, & remote start system

Table of Contents

Window Mount Antenna Module

This system is equipped with an outboard receiver or transceiver (2-way) module� It is designed

to be window mounted high on the windshield for optimal performance and range� It is best to

mount this module using the double sided stick pad included (be sure to clean glass before

adhering)� Mount it high in the windshield trying to avoid metal parts of the vehicle as they can

create "blind spots" for the antenna� Also, metal based window tint can have an adverse affect on

performance� Since the system's status lights and valet are contained in this module, high visibility

is also desired for theft deterrence� Route the harness to the antenna module being sure to avoid

sharp metal objects that could compromise the harness jacket�

This system includes 2 status lights that are built into the window mount antenna module� It is

desirable for these to be visible from as many angles around the vehicle as possible for maximum

visual theft deterrence� The control module has a separate port for the status light, so an optional

dash/custom mounted light can be utilized if desired�

This system includes a valet switch that is built into the window mount antenna module� The

control module has a separate port for the valet switch, so an optional custom mounted switch can

be used if desired�

When utilizing the tach wire circuit for engine detection, the vehicle's tach signal must be pro-

grammed to the remote start for proper operation� After making the tach wire connection, perform

the following steps:

Step 1: Turn the ignition key "ON"

Step 2: Within 5 seconds, press the brake pedal 5 times� (the siren will chirp 5 times)

Step 3: Start the engine� The status lights will turn on to indicate it has learned the current tach

signal� If it does not light, check your tach connection and start this procedure again�

Step 4: If the engine has a high idle at startup, it may be necessary to allow the idle to "settle"

to around 700 RPM� If needed, you can press the valet switch 1 time to resample the

tach signal. The status light will flash off then back on once the signal has been

resampled�

Step 5: Turn the ignition key "OFF"�

Table of Contents