Toshiba TLP-ET1E Owner's Manual page 43

Remove the lamp cover.
1
2
Pull out the lamp.
1
2
Mount the new lamp.
2
1
Replace the lamp cover.
2
1
Replace the tilt stand.
Put back the tilt stand using the reverse procedure to remove it.
Loosen the screw, put your fingers on the hollow, then pull up to
the direction of the arrow as shown in the figure to remove the
lamp cover.
Hollow
Loosen the two lamp locking screws, and pull up the handle to
remove the lamp.
Align the orientation, press down the new lamp until it reaches to
the bottom, and lock it in place using the two lamp locking screws.
Align the lamp cover, and press it in, then tighten the screws
loosened in Step 4 until the lamp cover is no longer loose.
(Continued)
43