LG AUUW096D Installation Manual page 28

Remote Controller Installation
Wired remote controller installation
• Since the room temperature sensor is in the remote controller, the remote controller box should be installed
in a place away from direct sunlight, high humidity and direct supply of cold air to maintain proper space
temperature. Install the remote controller about 5ft(1.5m) above the floor in an area with good air circulation
at an average temperature.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of the remote
controller LED's, the remote controller should be installed properly as shown in Fig.1.
(The standard height is 1.2~1.5 m from floor level.)
Wireless Remote Controller
HOW TO MOUNT ONTO A WALL
How to insert the Batteries
1. Remove the battery cover by
pulling it according to the arrow
direction.
2. Insert new batteries making sure
that the (+) and (-) of battery are
installed correctly.
3. Reattach the cover by sliding it
back into position.
28
Sun ray contact area
no
TIO N
B FU NC t
SU Pre hea
D ter idify r
SP EE O Hea t ros Hum t doo
FA N AUT Def Ou 4
JET Filt 2 er 3
MP HI 1
m Tem T TE p MED
SE Roo LO NE 23
ION ZO 21
ER AT 19
OP e 17
ING Tim 15
SW m set
AU TO Pro gra 13
11
09
unit 07
rati on 05
Ope 03
er 01
Tim Off Tim e
On no.
Set
no
Fig.1 Typical locations for remote controller
Direct
yes
TIO N
B FU NC t
SU hea
D ter Pre idify r
EE Hea t Hum t doo
SP N AUT O Def ros Ou 4
FA JET Filt er 3
MP HI 1 2
T TE p MED
SE m Tem LO 23
ION Roo ZO NE 21
AT 19
OP ER 17
Tim e
SW ING m set 15
TO gra 13
AU Pro 11
09
unit 07
on rati 05
Ope 03
er 01
Tim Off e
On no. Tim
Set
no
5feet
(1.5meters)
NOTICE
1. Always use/replace both batteries
of same type.
2. If the system is not to be used for
a long time, remove the batteries
to save their working life.
3. If the display screen of remote
controller starts, fading replace
both of the batteries.