Table of Contents
Advertisement
Missed call
Divert All Voice Calls in Line 1 and 2
Alarm clock
Keypad lock
Mute
Vibration
New message; no space for messages when blinking
Battery charge level
Technical Parameters
Handset
Type
Dimensions（W×L×H）
Weight
Battery
Continuous standby time
Continuous talk time
For other parameters about battery and charger, refer to their labels.
Battery
The accessory lithium battery of the handset can be immediately used after unpacking. A new battery will have
the best performance after full charge/discharge cycles for the first three times.
Removing & Installing the Battery
Remove: Switch off your phone, slide down the cover and then lift the battery from the compartment to remove it.
Install: Place the lower section of the battery into position, push down on the upper section of the battery until it
clicks into place and then install the battery cover.
Charging the Battery
Plug the charger connector into the charge port on the left side of the phone. (Note: Put upward the side with
arrow.) Then plug the other end of the charger in an appropriate electrical outlet.
Now, a charge indicator displays in the upper right corner of the screen. If the battery is charged in power-off
condition, the indicator bar will scroll. If the phone is over-used in shortage of battery or not used for a long time,
it will take a few minutes for the indicator bar to show.
When the battery is fully charged, the bar stops scrolling. Generally the whole charge process needs two to
three hours (charge the battery for six to eight hours for the first three times). Normally, during the charge
process, your phone, battery and charger may become hot.
Disconnect the charger with the phone and the power outlet when charge finished.
Warning:
Put the phone at a ventilated place with temperature between + 5℃ - + 40 .
chargers. Using unauthorized charger may cause danger and violate the authorization and warranty rules of the
phone.
Charge the battery in time when your phone automatically powers off or displays a warning "Battery low".
The conversation time and standby time of the phone lie on ideal working environments. In practice, the battery
working time varies with different network conditions, working environments and modes.
ZTE A137+
47.7 mm×106.9 mm×14.5 mm
Approx. 90 g (with battery)
Approx. 2000 hours - 250 hours (subject to network status)
Approx. 2 hours – 3 hours (subject to network status)
10
℃ Use only the supplied or approved
Advertisement
Table of Contents
