Table of Contents
Advertisement
Divert All Voice Calls
Alarm clock
Keypad lock
Mute
General mode
Vibration
Outdoor mode
New message; no space for messages when blinking
New MMS
Stopwatch
Headset mode
Battery charge level
Technical Parameters
Handset
Type
Dimensions（W×L×H）
Weight
Battery
Continuous standby time
Continuous talk time
For other parameters about battery and charger, refer to their labels.
Battery
The accessory lithium battery of the handset can be immediately used after unpacking. A new battery will have
the best performance after full charge/discharge cycles for the first three times.
Removing & Installing the Battery
Remove: Switch off your phone, slide down the battery cover and then lift the battery from the compartment to
remove it.
Install: Place the upper section of the battery into position, push down on the lower section of the battery until it
clicks into place and then install the battery cover.
Charging the Battery
Plug the charger connector into the charge port on the left side of the phone. Then plug the other end of the
charger in an appropriate electrical outlet.
Now, if the battery is charged in power-on condition a charge indicator displays in the upper right corner of the
screen. If the battery is charged in power-off condition, the indicator bar will scroll on the screen. If the phone is
over-used in shortage of battery or not used for a long time, it will take a few minutes for the indicator bar to
show.
When the battery is fully charged, the bar stops scrolling. Generally the whole charge process needs two to
three hours (charge the battery for six to eight hours for the first three times). Normally, during the charge
process, your phone, battery and charger may become hot.
Disconnect the charger with the phone and the power outlet when charge finished.
Warning:
ZTE A261FM
46.8 mm×108.5 mm×13.3 mm
Approx. 74 g (with battery)
Approx. 120 hours – 200 hours (subject to network status)
Approx. 2 hours – 3 hours (subject to network status)
8
Advertisement
Table of Contents
