Table of Contents
Advertisement
T-flash Card
ZTE A137+ supports T-flash card. You can use T-flash card to expand the storage of the phone. You can store or
copy files such as videos, photos, music, and so on.
Inserting & Removing the T-flash card
Inserting: The T-flash card slot is at the bottom of the phone. Open the cover. Insert the card with the metal
contacts facing up until it clicks to the right position.
Removing: Press and release the card to pop it out and then remove it.
Cautions for T-flash Card
Do not take out the card or switch off the phone while transmitting or storing data, which may cause data loss or
damage to the phone or the card.
Do not touch the metal contacts on the card with hands or metal objects. Use a soft cloth to clean the card.
Keep the card out of the reach of the children.
Connecting to the Network
SIM Card
Do not touch the metal contact area of the SIM card (Subscriber Identity Module card). Doing so may cause
information in the card lost or destroyed. Keep the card away from electricity and magnetism.
Inserting & Removing SIM Card
Switch off your phone, disconnect the outer power source and remove the battery.
Warning: It is forbidden to insert or remove the SIM card when it is on or connected to an outer power source.
Insert the SIM card into the SIM card slot or pull it out from the slot.
Switching on/off Your Phone
Hold the End key to power on/off the phone.
The mobile phone will automatically test whether the SIM card is plugged in and valid after power on, then the
following messages will be displayed on the screen sequentially.：
Enter Phone Lock——if a phone lock code has been set.
Enter PIN ——if a SIM card password has been set.
Searching ——search for the right network.
Connecting to the Network
After the phone and the SIM card are unlocked, the mobile phone will automatically search for the network. After
a few seconds, your phone will be registered on the network. Now your phone is in the standby mode. Besides
receiving and sending calls, you can do the following things:
Press the Left soft key to enter the function menu.
Press the Right soft key to enter the Name [Phone Book List].
Press the Up/Down/Left/Right key to enter Audio Player/Alarm/User Profiles/Tone Setup, respectively.
Note: If "Emergency" is shown on the screen, you can only make emergency calls.
In the standby mode, press the Left soft key and then the * key within two seconds to lock the keypad.
The unlock method is the same. Locking the keypad can prevent the unintentional operations on it. You can
answer an incoming call with the regular operation when locked.
11
Advertisement
Table of Contents
