Technical Parameters; Battery; Removing & Installing The Battery; Charging The Battery - Zte A611+ User Manual

Gsm dual-band gprs digital
Table of Contents

Advertisement

Mute
Vibration
New message; no space for messages when blinking
Battery charge level

Technical Parameters

Handset
Type
Dimensions(L×W×H)
Weight

Battery

Continuous standby time
Continuous talk time
For other parameters about battery and charger, refer to their labels.
Battery
The accessory lithium battery of the handset can be immediately used after unpacking. A new battery will have
the best performance after full charge/discharge cycles for the first three times.
Removing & Installing the Battery
Remove: Switch off your phone, slide down the cover and then lift the battery from the compartment to remove it.
Install: Insert the battery by aligning the metal contacts on the battery with the metal contacts in the battery
compartment on the phone. Push down the battery until it clicks into place and then install the battery cover.

Charging the Battery

Plug the charger connector into the charge port on the left side of the phone. (Note: Put upward the side with
arrow.) Then plug the other end of the charger in an appropriate electrical outlet.
Now, a charge indicator displays in the upper right corner of the screen. If the battery is charged in power-off
condition, the indicator bar will scroll. If the phone is over-used in shortage of battery or not used for a long time,
it will take a few minutes for the indicator bar to show.
When the battery is fully charged, the bar stops scrolling. Generally the whole charge process needs two to
three hours (charge the battery for six to eight hours for the first three times). Normally, during the charge
process, your phone, battery and charger may become hot.
Disconnect the charger with the phone and the power outlet when charge finished.
Warning:
Put the phone at a ventilated place with temperature between + 5℃ - + 40 .
chargers. Using unauthorized charger may cause danger and violate the authorization and warranty rules of the
phone.
Charge the battery in time when your phone automatically powers off or displays a warning "Battery low".
The conversation time and standby time of the phone lie on ideal working environments. In practice, the battery
working time varies with different network conditions, working environments and modes.

Connecting to the Network

SIM Card

Do not touch the metal contact area of the SIM card (Subscriber Identity Module card). Doing so may cause
information in the card lost or destroyed. Keep the card away from electricity and magnetism.
ZTE A611+
93 mm×47.8 mm×15.9 mm
Approx. 80 g (with battery)
Approx. 120 hours - 150 hours (subject to network status)
Approx. 2 hours – 3 hours (subject to network status)
9
℃ Use only the supplied or approved

Advertisement

Table of Contents
loading

Table of Contents