Table of Contents
Advertisement
rDo not use near other wireless equipment.
The following equipment may use radio waves in the same band as the projector.
When the projector is used near these devices, radio wave interference may make communication impossible, or
the communication speed may become slower.
f Microwave ovens, etc.
f Industrial, chemical and medical equipment, etc.
f In-plant radio stations for identifying moving objects such as those used in factory manufacturing lines, etc.
f Designated low-power radio stations
r If at all possible, avoid the use of cellular phones, TV sets or radios near the projector.
Cellular phones, TV sets, radios and similar devices use different radio bands from the projector, so there is no
effect on wireless communication or the transmission and reception of these devices. However, radio waves from
the projector may produce audio or video noise.
r Wireless communication radio waves cannot penetrate steel reinforcements, metal,
concrete, etc.
Communication is possible through walls and floors made from materials such as wood and glass (except glass
containing wire mesh), but not through walls and floors made from steel reinforcements, metal, concrete, etc.
r Avoid using the projector in locations prone to static electricity.
If the projector is used in a location prone to static electricity, the wireless LAN or wired LAN connection may be
lost.
If the static electricity or noise make it impossible to establish a connection with the LAN, disconnect the power
plug from the outlet after turning off the projector power, eliminate the source of static electricity or noise, then turn
on the projector.
rUsing the projector outside the country
Note that depending on countries or regions, there are restrictions on the channels and frequencies at which you
can use the wireless LAN.
Application software supported by the projector
The projector supports following application software. For details or downloading each application software, visit
the Panasonic website (https://panasonic.net/cns/projector/).
f Logo Transfer Software
This application software transfers the original image, such as company logo, which is projected at the start, to
the projector.
f Multi Monitoring & Control Software
This application software monitors and controls the multiple display devices (projector and flat panel display)
connected to an intranet.
f Early Warning Software
This plug-in software monitors the status of the display devices and their peripherals within an intranet, and
notifies of abnormality of such equipment and detects the signs of possible abnormality. "Early Warning
Software" is preinstalled in the "Multi Monitoring & Control Software". To use the early warning function of
this plug-in software, install "Multi Monitoring & Control Software" in the PC to be used. By enabling the early
warning function, it will notify of the approximate time to replace the consumables for the display devices,
to clean each part of the display devices, and to replace the components of the display devices, allowing to
execute maintenance in advance.
The early warning function can be used by registering maximum of 2048 display devices free of charge for
90 days after installing the "Multi Monitoring & Control Software" into a PC. To continuously use after the 90
days, it is necessary to purchase the license of "Early Warning Software" (ET-SWA100 Series) and perform
the activation. Also, depending on the type of license, the number of display devices that can be registered for
monitoring varies. For details, refer to the Operating Instructions of "Multi Monitoring & Control Software".
f Presenter Light Software
This application software compatible with Windows computers transmits the computer screen to the projector
via wireless LAN or wired LAN.
f Wireless Projector
This application software for iOS/Android is used to project files such as PDF or image by transmitting to the
projector via wireless LAN.
16 - ENGLISH
Chapter 1 Preparation - Precautions for use
Advertisement
Chapters
Table of Contents
