ActionTec ScreenBeam Pro User Manual page 68

3. Go to the Firmware Upgrade tab page by clicking the Firmware Upgrade tab.
4. On the Firmware Upgrade tab page, you can check the current firmware version in the
Firmware Version section and upgrade the receiver.
5. Select Enable in the Firmware Update box.
6. Download the latest firmware from Actiontec's website:
http://www.actiontec.com/sbupdate.
Note: You should disconnect from the receiver's SSID and connect to a router's SSID
before downloading firmware.
7. Extract the zip file. You will find one "autorun" folder and one "install.img" file in the
extracted file folder.
8. Copy the "autorun" folder and the "install.img" file to the root directory of a USB flash
drive.
Note: Do not use a portable hard drive. You should use a FAT/FAT32 formatted USB
flash drive only.
9. Make sure the "Ready To connect" screen appears on your TV.
Note: You must disconnect your device (laptop, ultrabook, smartphone or tablet) from
the receiver before upgrading your receiver.
10. Plug the USB flash drive into the USB port on ScreenBeam Pro.
11. The Receiver starts to update its firmware automatically. Firmware upgrade status
messages appear on your TV.
Warning! Do not power off the Receiver or remove the USB flash drive while the
upgrade is in progress. Otherwise, firmware upgrade fails.
12. The Receiver reboots after firmware update completes.
64