Table of Contents
Advertisement
Quick Start
2.3
Step 3
After the firmware file has successfully downloaded to the LaunchPad™, unplug the USB cable from the
LaunchPad™. Further communication takes place using the USB connector located at the opposite end of
the LaunchPad™. For proper power to be supplied to the BOOSTXL-ADS1119, remove the jumper from
the middle of the LaunchPad™ at JP6 and place the jumper on the center pins of JP1; see
jumper takes the available USB power from the bottom connector and applies the voltage to the remainder
of the board.
Before plugging the USB cable to the bottom LaunchPad™ USB connector, properly align the connectors
(as shown in
Figure
connectors on the LaunchPad™.
When the BoosterPack™ is attached, plug the USB cable into the bottom connector of the LaunchPad™
and also to the PC. The LaunchPad™ communication to the PC is USB communications device class
(CDC) using a virtual COM port. Windows
the operating system may require a manual driver installation. The required driver files can be found in the
installation directory Program Files (x86)/Texas Instruments/ADS1119/drivers.
2.4
Step 4
From the Windows Start menu, go to the Texas Instruments folder and under ADS1119 start the GUI
application. The communication should automatically connect. If the hardware does not connect, manually
try to make the connection by clicking on the connect icon in the lower left portion of the GUI. A different
COM port can be selected by using the information from
6
BOOSTXL-ADS1119 BoosterPack™ User's Guide
4) and attach the BOOSTXL-ADS1119 BoosterPack™ to the bottom set of
Figure 4. LaunchPad™ and BoosterPack™ Combo
10 automatically installs the required driver. Earlier versions of
®
Copyright © 2018, Texas Instruments Incorporated
Section
2.2.2.1.
Submit Documentation Feedback
www.ti.com
Figure
16. This
SBAU322 – August 2018
Advertisement
Table of Contents
