Alert Lists - Furuno FAR-2807 Operator's Manual

APPENDIX

7. Alert Lists

System Errors
Alert name Priority
AZIMUTH Warning
HEADLINE Warning
RF Warning
TRIGGER Warning
VIDEO Warning
KEY Warning
Sensor Errors
Alert name Priority
GYRO Warning
LOG(BT) Warning
LOG(WT) Warning
EPFS Warning
DATUM Warning
UTC Warning
AP-56
Meaning
No antenna rotation signal
No heading signal
No RF communications signal
No trigger signal
No video signal
No key signal
Meaning
The indication "GYRO" (in
yellow-orange) appears and the
HDG indication reads "***.*°". The
orientation mode is automatically
set for head-up. TT, radar map,
AIS, and echo averaging are
disabled.
The indication "LOG(BT)" (in
yellow-orange) appears and the
and the speed indication shows
"**.* kn" if the ground speed
signal is lost for more than 30 s.
CPA and TCPA for AIS are not
calculated.
The indication "LOG(WT)" (in
yellow-orange) appears and the
speed indication shows "**.* kn" if
the water speed signal is lost for
more than 30 s.
The indication "EPFS" (in
yellow-orange) appears and the
position display shows all
asterisks if the position input is
lost for more than 30 s. Radar
map, AIS, and echo averaging
are disabled.
This error will also occur if IMO
settings are operational and GPS
types are changed. (EG: DGPS to
GPS).
For the IMO type, the indication
"DATUM" (in yellow-orange)
appears if the datum is other than
WGS-84 or WGS-84 is not input.
AIS is inoperative with datum
other than WGS-84.
No ZDA input.
Action required
Acknowledge indication by
pressing the [ALARM ACK] key or
left-clicking the Alert box.
Restore signal or rectify reason for
signal loss to remove indication.
Action required
Match the on-screen HDG
indication with the actual compass.
The indication "HEADING SET"
appears. Press the [ALARM ACK]
key to erase the indication.
If the SDME has failed, use
another speed sensor.
Acknowledge indication by
pressing the [ALARM ACK] key or
left-clicking the Alert box. Restore
signal to remove indication. This
message cannot be erased if
position signal is missing; it is
automatically erased when the
signal is restored.
Acknowledge indication by
pressing the [ALARM ACK] key or
left-clicking the Alert box. Use
WGS-84 datum.
Acknowledge indication by
pressing the [ALARM ACK] key or
left-clicking the Alert box. Restore
signal to remove indication.