Table of Contents
Advertisement
4.
5.
6.
To prevent unused detergent from flowing into the outlet during
²
the next wash: Pour 1 litre of water into dispenser II and start the
0 [
set rpm (spin speed) to - - -).
Drainage hose on the siphon blocked
1.
Note: Residual water may run out.
2.
3.
4.
30
Carefully unscrew the pump cover. Clean the interior, pump
cover thread and pump housing (fan impeller in the
detergent-solution pump must rotate).
Reinsert and screw on the pump cover. Handle should be
vertical.
Close service flap.
Spin/Drain programme: (if only a drained cycle is required:
Switch off appliance. Remove the mains plug.
Loosen hose clip, carefully remove drainage hose.
Clean the drain hose and siphon connecting piece.
Reattach the drain hose and secure the connection point
using the hose clamp.
Advertisement
Table of Contents
