Table of Contents
Advertisement
Faults
Loud noises, vibra-
tions and machine
"movement" during
the spin cycle.
The colon on the
Ready in in display :
stops flashing.
The single dot (.)
flashes.
The display panel/in-
dicator lamps do not
work while the appli-
ance is running.
There is detergent
residue on the laun-
dry.
appears in the
¯‹
display panel in re-
load mode.
and the
I
+
¯‹
A
Start/Reload
button are flashing in
the display panel in
reload mode.
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
– Switch off the appliance and pull out the mains plug.
– Turn off the tap and call customer services. ~ Page 35
34
Cause/Remedy
– Is the appliance aligned?
Level the appliance. ~ Page 45
– Are the appliance's feet fixed?
Secure the appliance's feet. ~ Page 45
– Have the transportation protection devices been removed?
Remove the transportation protection devices. ~ Page 40
Mains voltage too low ~ Page 27
Undervoltage during the washing programme causes an extending
of the wash programme. ~ Page 27
– Has there been a power failure?
– Have the fuses blown? Reset/replace the fuses.
– If the fault occurs repeatedly, call customer services.
~ Page 35
– Some phosphate-free detergents contain water-insoluble resi-
due.
– Select
Rinse or brush the laundry after washing.
O
– The water level is too high. It is not possible to add laundry.
Close the door immediately, if necessary.
– Select
Start/Reload to continue the programme.
A
It is not possible to add laundry. Wait until
(approx. 1 min).
are lit
I
+
¢"†
Advertisement
Table of Contents
