Table of Contents
Advertisement
IMPORTANT: All or a part of operation in this chapter may not be
available to dealer-programmed units.
The default setting list is available on P29.
1.
Press and hold
key for over 2 seconds to enter the parameter
setting mode.
2.
Press
or
to select the desired menu.
3.
Turn
Main Dial to select the desired parameter.
4.
Press
to confirm and exit.
Frequency Step Setup
Only in VFO mode, this function is valid. Turn Main Dial to select
frequency step.
1.
Press and hold
key for over 2
seconds to enter setting menu.
2.
Press
/
key to choose No.01 menu, LCD displays "STP--
125"
3.
Turn
Main Dial to select the desired frequency channel step.
Available steps in KHz are:
4.
Press
key to confirm and exit
This function is not available in memory-mode.
DTMF, DTMF ANI, 2Tone or 5Tone Signaling
DTMF/5Tone/2Tone signalling are used for selective-calling. DTMF
and 5Tone signalling can be applied for other advanced features such
as ANI, PTT ID, group call, remotely stun,remotely kill, waken,...etc.
The signalling edition must be done in advanse to operatins through
12.5
PARAMETER SETTING MODE
programming software.
1.
Press and hold
seconds to enter into setting menu.
2.
Press
/
LCD displays "T-OFF" .
3.
Turn Main Dial to
"DTMF": the channel will be mute by a DTMF signal. The
speaker won't sound until receiving a correspondent DTMF
signal. Hold "PTT" then press [UP] directly to transmit the pre-
stored DTMF tones.
In DTMF signaling mode, press
displays "AN---", turn Main Dial to select desired digit(the other
party ID).In this mode, press
cursor to next, press
key to operate ANI call.
"2TONE": the channel will be mute by
a 2-Tone signal. The speaker won't
sound until receiving a correspondent
2-Tone signal.Hold "PTT" then press
[UP] to transmit the pre-stored 2-Tone
signal.
"5Tone": the channel will be mute by
a 5-Tone signal. The Speaker won't
sound until receiving a correspondent 5-Tone signal. hold [PTT]
then press [UP] directly to transmit the pre-stored 5-Tone signal.
key for over 2
to choose No 2 menu,
select the desired setup.
for 2 seconds until LCD
to confirm exist digit and move
to forward cursor. After editing, press
7
16
Advertisement
Table of Contents
