Configure The Settings Relating To The Camera Action On Alarm Occurrence [Alarm] - Panasonic WV-SW395APJ Operating Instructions Manual

13 Configure the alarm settings [Alarm]
The following port numbers are unavailable since they are already in use.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 554, 995, 10669, 10670, 59000-61000
13.2 Configure the settings relating to the camera
action on alarm occurrence [Alarm]
Click the [Alarm] tab on the "Alarm" page. (®page 47, page 49)
The settings relating to the camera action at an alarm occurrence can be configured in this section. Refer to
pages 134, 138 and 141 for further information about the settings relating to the alarm, the alarm image and
the alarm output terminal.
Camera action on alarm
[Terminal alarm 1]
Select an action to be taken when a terminal alarm 1 is detected from the following.
•
Off: Does not take any action even when a terminal alarm 1 is detected.
•
1-64
SW395 SW395
preset position is selected, the camera will move to the selected preset position when a terminal alarm 1
is detected.
•
Auto track
SW395 SW395
•
1-256
SW396 SW396
detected, the camera will move to that position.
•
Auto track
SW396 SW396
•
Patrol 1
SW396 SW396
* If Patrol 1 is not registered it is not displayed on the screen.
•
Default: Off
[Terminal alarm 2]
136 Operating Instructions
SC385 SC385 SC384 SC384 SW175 SW175
: When a terminal alarm 1 is detected, the camera will start the auto tracking.
SC385 SC385
: If a previously registered preset position is selected, when a terminal alarm 1 is
SC386 SC386
: When a terminal alarm 1 is detected, the camera will start the auto tracking.
SC386 SC386
: When a terminal alarm 1 is detected, the camera will start the patrol.
SC386 SC386
SW174W SW174W SW172 SW172 ST165 ST165
: When the registered
ST162 ST162