Table of Contents
Advertisement
23 Troubleshooting
Before asking for repairs, check the symptoms with the following table.
Contact your dealer if a problem cannot be solved even after checking and trying the solution in the table or a
problem is not described below.
Symptom
Cannot access from the web
browser.
Cause/solution
•
Is the LAN cable (category 5 or better, STP*) firmly
connected to the network connector of the camera?
*For Europe
•
Is the link indicator lit?
When it is not lit, connection to a LAN may not be
established or a network may be not working
correctly. Check if the cables have any contact
failure or if the wiring is correct or not.
•
Is the power of the camera on?
Check if the power of the camera is turned on.
•
Are the set IP addresses valid?
•
Are you accessing the wrong IP address?
Check the connection as follows.
With the Windows command prompt, > ping "IP
address of the camera".
If there is reply from the camera, the connection is
normal.
If not, proceed either of the following.
–
Reboot the camera and change the IP address
by using the Panasonic "IP Setting Software"
within 20 minutes after the restart.
–
Reboot the camera while holding down the
[INITIAL SET] button (or switch) on the camera.
The camera will be initialized and the IP address
will return to the default setting "192.168.0.10".
After the camera is initialized, access the
camera and set the IP address again. (When the
camera is initialized, all the settings of the
camera previously configured on the setup
menus will be initialized.)
•
Is "554" selected for the HTTP port number?
For the HTTP port number, select a port number
other than the following port numbers used by the
camera. The number used by the camera: 20, 21,
23, 25, 42, 53, 67, 68, 69, 110, 123, 161, 162, 443,
554, 995, 10669, 10670, 59000 - 61000
23 Troubleshooting
Reference pages
Installation Guide
Installation Guide
Installation Guide
166
-
Installation Guide
169
Operating Instructions
231
Advertisement
Table of Contents
