Governor Oil Filter - Change; Oil Pipe - Inspect - Mitsubishi S6R2 Operation & Maintenance Manual

Governor Oil Filter - Change

When draining oil or changing the oil filter, wear
gloves. Hot engine oil and parts may cause burns.
1. Prepare a drip pan and place it under the governor
oil filter.
2. Loosen the air vent plug and remove the drain plug.
Drain oil from the filter into the drip pan.
3. Remove the oil pipe from the center bolt.
4. Remove the center bolt and remove the case from
the bracket. Remove the used element from the
case.
5. Put a new element in the case using the center
bolt.
6. Install the case to the filter bracket. Tighten the
center bolt.
7. Install the oil pipe to the center bolt.
8. Install the drain plug.
9. Remove the air vent plug. Fill up the filter with en-
gine oil.
10. After filling up, reinstall the air vent plug.

Oil Pipe - Inspect

Oil Pipe and Clip - Inspect and Replace
Visual Inspection at Overhaul
Loosen clamp fixing bolt and check clip wear and pipe
wear. If defective, replace the pipe assembly with a
new one.
In Every Other Major Overhaul
Replace the pipe assembly with a new one.
Chapter 8 PERIODIC INSPECTION AND MAINTENANCE PROCEDURES
Fig. 8-19 Oil Pipe and Clip - Inspect and Replace
Air vent plug
Drain plug
Oil pipe
Fig. 8-17 Governor oil filter - Drain
Center bolt
Fig. 8-18 Governor oil filter - Change
Clip
Element
Case
Clamp
8-15