Ap Repeater Mode - TRENDnet TEW734APO User Manual

TRENDnet User's Guide
 Extension channel: When 20/40 channel bandwidth has been chosen, you should
select extension channel to get higher throughput.
 Channel Mode: 20MHz and 40MHz. The last one can enhance data throughput,
but it takes more bandwidth, thus it might cause potential interference.
 Data Rate: Usually "Auto" is preferred. Under this rate, the IEEE 802.11b/g/n
Wireless CPE will automatically select the highest available rate to transmit. In
some cases, however, like where there is no great demand for speed, you can
have a relatively-low transmit rate for compromise of a long distance.
 Maximum Output power: Specify the signal transmission power. The higher the
output power is, the wider the signal can cover, but the power consumption will
be greater accordingly.
Wireless >WDS Setting
This section outlines the available management options under the WDS Settings of the
Wireless button. WDS Settings is available only under Bridge and AP Repeater Mode.
 WDS Separation: Enable separates all configured WDS AP to communicate with
each other.
 Remote AP: Enter the MAC address of the access point you want to WDS with.
Note: You must enter the MAC address of every access point in the WDS
network. Each wireless setting (SSID, channel, wireless encryption) must match
on each access point in the WDS network.
© Copyright 2015 TRENDnet. All Rights Reserved.

AP Repeater Mode

AP Repeater mode allows the access point to repeat a wireless signal of an existing
wireless network. This section outlines available management options when the device
System Setting is set to Bridge and the wireless Operation Mode is set to AP Repeater.
Click Apply to save any changes.
TEW-734APO
17