Making Coffee Using Pre-Ground Coffee; Customising Strength And Quantity; Truebrew Over Ice™ Coffee; Programming Over Ice Lenght - DeLonghi Dinamica Manual

Please note:
• The variation in aroma is not saved and the next time a
beverage is delivered automatically, the machine selects
the default value.
• If a few seconds elapse between temporary customising of
the aroma and delivery of the beverage, the aroma returns
to the default value.

13.5 Making coffee using pre-ground coffee

Important!
• Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the machine.
• Never use more than 1 level
measure (C2) or it could dirty the
inside of the coffee machine or
block the funnel (A4).
Please note:
If you use pre-ground coffee, you can only make one cup of
coffee at a time.
1. Press the icon (B8) repeatedly until the
(B6) comes on.
2. Make sure the funnel is not blocked, then add one level
measure of pre-ground coffee (fig. 12).
3. Place a cup under the coffee spouts (A19) (fig. 10).
4. Then select your required coffee:
Recipe
Espresso (B10)
Espresso Lungo (B11)
Long (B13)
5. Preparation begins. When delivery finishes, the light corre-
sponding to the selected icon flashes on the touch screen
(B) indicating the possibility to increase the quantity in the
cup, within 3 seconds, by pressing the icon.
X-STRONG
(see "13.5 Making coffee
using pre-ground coffee")
light
Quantity
≃ 1.35 floz/40 ml
≃ 4.06 floz / 120 ml
≃ 5.41 floz / 160 ml
Important! Making LONG coffee
ground coffee:
Halfway through preparation, the
level measure of pre-ground coffee and press
Please note:
If "Energy Saving" mode is active, you may have to wait a few
seconds before the first coffee is delivered.

13.6 Customising strength and quantity

The machine is set by default to make coffee with a standard
strength and quantity (see table in section "13.3 Making coffee
using coffee beans").
To customise the coffee, proceed as follows:
1. Place a sufficiently large cup or glass under the coffee
spouts (A19);
2. Press (B8) to select the required strength (see sec-
tion "13.4 Temporarily varying the coffee strength");
3. Press and hold the icon corresponding to the coffee to be
customised. The icon flashes and all the alarm lights flash 4
times;
4. Release the icon. The icon flashes and the machine starts
delivering coffee;
5. As soon as the coffee in the cup reaches the required level,
press the coffee icon again.
The strength and quantity of coffee in the cup has now been
programmed.
14. TRUEBREW OVER ICE™ COFFEE
1. Place 3 ice cubes in a large glass (fig. 13), press the
strength selector
or extra strong recommended), and place the glass under
the brewing unit;
2. Then, press the
the coffee (fig. 14);
3. Add 3 more ice cubes to the glass/coffee plus any syrup,
sweetener or milk desired and enjoy
Important!
Always use glasses resistant to thermal shock.

14.1 Programming over ice lenght

1. Press the TrueBrew Over Ice™ button (B12):
flashes indicating that it is necessary to select the strength;
2. Press (B8) to select the required strength (see sec-
tion "13.4 Temporarily varying the coffee strength") ;
13
using pre-
light flashes. Add one
OK (B15).
(B8) to choose a strength (strong
TrueBrew Over Ice™ button to brew
(B8)