Philips HD5730/11 User Manual page 13

4 Open the lid of the ground coffee container and put one level
measuring spoon of ground coffee in the funnel.
5 Brew 1 cup of coffee as described in 'Brewing espresso from coffee
beans'.
When you use ground coffee, you cannot brew 2 cups at the same time.
6 If you want to make coffee from beans instead of ground coffee again,
press the coffee strength/ground coffee button and select the desired
coffee strength with the ^ or % button.
7 Press the OK button to confirm the desired coffee strength.
Changing the coffee quantity for espresso
The appliance is preset to brew the following coffee quantities:
- short coffee: 40ml
- standard coffee: 80ml
- long coffee: 120ml
To change the standard quantities, proceed as follows:
1 Put a cup under the coffee spout.
2 Press the button for short coffee, standard coffee or long coffee,
depending on which quantity you want to change. Press this
button for 5 seconds UNTIL the message 'PROGRAM TO SET VOL...'
appears on the display and then release it.
The appliance starts to brew coffee.
,
3 When the coffee in the cup reaches the required level, press the
same button again to set the new quantity.
'SETTING DONE!' appears on the display. The appliance now brews
,
the set quantity until you change it again.
Brewing cappuccino or latte macchiato
1 Move the release slide towards you and remove the lid of the milk
jug.
2 Fill the milk jug with approx. 150ml milk for each cappuccino or latte
macchiato to be prepared.
- It is advisable to use fresh skimmed or fresh semi-skimmed milk at
refrigerator temperature (about 5°C).
3 Make sure the milk intake tube is properly inserted into the rubber
ring.
EnglisH
13