Rinnai RIBF25N Operation & Installation Manual page 22

HEATER ENGINE INSTALLATION - MASONRY
Step 4. Positioning the Heater Engine
Place the heater engine in front of the fireplace enclosure.
A panel from the cardboard packing carton
placed on the floor underneath the heater will
HINT
help prevent possible damage to flooring.
Step 5. Connect Electrical Supply
Plug in the 3 pin connector if electrical connections inside the
fireplace.
Step 6. Insert Heater Engine Into Fireplace
Carefully move the heater engine into the fireplace ensuring
the gas supply pipe and fittings
hole.
Take care that the electrical cord does not bunch
up or get pinched behind the heater engine.
CAUTION
Step 7. Connecting Gas
Connect gas supply pipe and fittings
valve inlet and tighten.
F
Step 8. Leak Testing
Turn gas back ON and leak test all appliance connections.
Use a soapy solution to test all gas connections.
If a leak is present bubbles will form at the leak
CAUTION
point. When finished remove any residue with a
rag. Prevent any soapy solution from coming in
contact with electrical components.
Step 9. Securing The Heater Engine
Fasten the heater to the masonry work using appropriate
fasteners (not supplied) using the three holes across the top of
the fascia assembly mounting panel and in at least two of the
holes on each side of the side panels as shown
Step 10. Completing Heater Installation
Go to "COMPLETING HEATER INSTALLATION" on page 23.
Rinnai Australia
feed into the rear access
E
to the gas control
E
.
G
19
E F
G
Slimfire 252 Operation & Installation Manual
E
F
E