Agilent Technologies 54810A User's Quick Start Manual page 27

3 Set the printer configuration to use the "Centronics" or "Parallel"
interface, if necessary. See the documentation for your printer.
4 Go to "To install the printer software" in Chapter 3.
5 Connect the 9-pin "D" connector of the serial printer cable to the serial
output port on the rear panel of the oscilloscope. Tighten the
thumbscrews to secure the cable.
Figure 1-17
Attaching the 9-pin "D" Connector
6 Attach the 25-pin "D" connector to the serial input port of the printer.
Tighten the thumbscrews to secure the cable.
Figure 1-18
Attaching the 25-pin "D" Connector
7 Set the printer configuration to use the serial interface. See the
documentation for your printer.
8 Go to "To install the printer software" in Chapter 3.
Setting Up the Oscilloscope
To connect a printer
Port on Printer
1-23