Image Colors Are Not Right - Epson EB-L1750U User Manual

Problem Solving
Check
Is the display range restricted by Blanking?
Is the image position adjusted correctly?
Is the computer set for dual display?
(Only when projecting computer images)
Is the correct resolution selected?
(Only when projecting computer images)
Is the image direction correct?

Image colors are not right

Check
Do the input signal settings match the signals from the connected
device?
Is the image brightness adjusted correctly?
Are the cables connected correctly?
g
Is the Contrast adjusted correctly?
Is the color adjustment set correctly?
Appropriately set Blanking in the configuration menu.
s Signal - Blanking p.147
(Only when projecting analog RGB signals input from the Computer port)
Press the [Auto] button on the remote control or the [
You can also adjust the position from the Configuration menu.
s Signal - Position p.147
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s Computer video driver documentation
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.276
s Computer's documentation
Make the correct settings in Projection from the Configuration menu.
s "Installation Settings" p.30
Change the setting according to the signal for the connected equipment.
s Signal - Advanced - Input Signal
Adjust the Brightness setting from the Configuration menu.
s Image - Brightness p.145
Check that all the cables required for projection are securely connected.
Check that no cables are disconnected and that there are no poor contacts in the cables.
s "Connecting Equipment" p.49
Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.145
Adjust the Gamma or RGBCMY setting from the Configuration menu.
s Image - Advanced p.145
s "Adjusting the Image" p.85
Remedy
] button on the control panel to adjust the position.
Remedy
p.147
199