Advertisement
2 Slide a suitable styler or crimping/straightening plates onto the
attachment.
•
To remove the crimping/straightening plate, grab the cool tip (
and pull it off.
3 Place the appliance with the support ( ) outwards on a heat-resistant
surface.
4 Connect the plug to a mains socket.
5 Slide the on/off switch ( ) to I to switch on the appliance.
The power-on indicator (
»
When the appliance is ready for use, the ready indicator (
»
changes colour from red to dark.
6 Comb your hair and divide your hair into small sections that are not
wider than 5-6cm.
7 Move the support ( ) backwards.
Create curls or ringlets
1 Press the lever ( ) to open the clip ( ) and place a section of hair
between the clip and barrel ( ).
2 Release the lever and slide the barrel to the hair tip.
3 Hold the cool tip ( ) and the handle, and then wind the section of
hair round the barrel from end to root.
•
If you use the attachment with the spiral, wind the section of hair
round the barrel following the spiral profile.
4 Hold the barrel in the position for max. 15 seconds, and then unwind
the section of hair until you can open the clip again with the lever or
until you can remove the spiral from your hair.
5 To style the rest of your hair, repeat steps 1 to 4.
Create waves
1 Wind a section of hair round the brush.
2 Hold the barrel in the position for max. 15 seconds, and then unwind
the section of hair to remove the brush from your hair.
3 To style the rest of your hair, repeat steps 1 to 2.
) lights up.
)
)
Advertisement
