Appendices; Troubleshooting; Image - Optoma DS512 Manual

Appendices

Troubleshooting

If you experience a problem with your projector, please refer to the
following information. If a problem persists, please contact your local
reseller or service center.

Image

English 44
Ensure all the cables and power connections are correctly and
4
securely connected as described in the
Ensure all the pins of connectors are not bent or broken.
4
Check if the projection lamp has been securely installed.
4
Please refer to the
Press "Re-Sync" on the remote.
4
If you are using a PC:
4
For Windows 95, 98, 000, XP:
. Open the
then double click on the
. Select the
3. Verify that your display resolution setting is lower than or
equal to UXGA (600 x 00).
4. Click on the
If the projector is still not projecting the whole image, you
will also need to change the monitor display you are using.
Refer to the following steps.
5. Verify the resolution setting is lower than or equal to UXGA
(600 x 00).
6. Select the Change button under the
7. Click on
under the SP box; choose the resolution mode you
need under the "Models" box.
8. Verify that the resolution setting of the monitor display is
lower than or equal to UXGA (600 x 00). (*)
section.
icon, the
icon.
tab.
button.
. Next, select
section.
folder, and
tab.