Precautions - Optoma DS512 Manual

Usage Notice

Precautions

▀■
▀■
▀■
▀■
▀■
When the
v
lamp reaches
the end of its
life, the
▀■
projector will
not turn back
on until the
lamp
module
▀■
has been
replaced. To
replace the
lamp, follow
the procedures
▀■
listed under
"Replacing the
Lamp" section
on page 50.
▀■
English 4
Please follow all warnings, precautions and
maintenance as recommended in this user's
guide.
Warning - Do not look into the projector's lens when the lamp is
on. The bright light may damage your eyes.
Warning - To reduce the risk of fire or electric shock, do not
expose this projector to rain or moisture.
Warning - Please do not open or disassemble the projector as
this may cause electric shock.
Warning - When replacing the lamp, please allow unit to cool down,
and follow all replacement instructions. See page 50.
Warning - This projector will detect the life of the lamp itself. Please
be sure to change the lamp when it shows warning
messages.
Warning - Use the "Lamp Reset" function from the on-screen display
"Options | Lamp Settings" menu after replacing the lamp
module (see page 4).
Warning - When switching the projector off, please ensure the
cooling cycle has been completed before disconnecting
the power. Allow 90 seconds for the projector to cool
down.
Warning - When the lamp is approaching the end of its life, the
message "Lamp is approaching the end of its useful
life" displays on the screen. Please contact your
local reseller or service center to change the lamp
as soon as possible.
Warning - To reduce the risk of injury to the eyes, do not look
directly into the laser beam on the remote control and
do not point the laser beam into anyone's eyes. This
remote control is equipped with a Class II laser that emits
radiation.