Toshiba RAS-25N4KVRG-ND Service Manual page 126

12-2. Outdoor unit
No.
Part name
Common procedure
1
Front cabinet
2
Procedures
1. Detachment
NOTE
Wear gloves for this job.
Otherwise, you may injure your hands on
the parts, etc.
1) Stop operation of the air conditioner, and
turn off the main switch of the breaker for air
conditioner.
2) Remove the valve cover.
(ST2TØ4 × 10L 2 pcs.)
• After removing screw, remove the valve
cover pulling it downward.
3) Remove cord clamp (ST2TØ4 × 14L 3 pcs.),
and then remove connecting cable.
4) Remove the upper cabinet.
(ST1TØ4 × 10L 5 pcs.)
• After removing screws, remove the upper
cabinet pulling it upward.
1. Detachment
1) Perform step 1 in 1.
2) Remove the fixing screws (ST2TØ4 × 10L
2 pcs.) used to secure the front cabinet and
inverter cover, the screws (ST2TØ4 × 10L
4 pcs.) used to secure the front cabinet at
the bottom, and the fixing screws (ST2TØ4
× 10L 2 pcs.) used to secure the motor
base.
• The front cabinet is fitted into the side
cabinet (left) at the front left side so pull
up the top of the front cabinet to remove
it.
2. Attachment
1) Insert the claw on the front left side into the
side cabinet (left).
2) Hook the bottom part of the front right side
onto the concave section of the bottom
plate. Insert the claw of the side cabinet
(right) into the square hole in the front
cabinet.
3) Return the screws that were removed
above to their original positions and attach
them.
Claw
- 126 -
Remarks
Upper cabinet
Screw ST2T
Screw ST1T
Front cabinet
Square
hole
Concave section
Valve cover