Elation FUZE SFX User Manual page 14

G O B O I N S TA L L AT I O N
3. Optional. This step may be performed to help improve access to the gobo wheel module. On
the prism module, find the 4-pin connector (denoted by the yellow box, above right) that is
located behind the left-most electric motor, just beside the thumb screw on the left hand
side of the prism module. Disconnect this connector.
4. Optional. This step may be performed to help improve access to the gobo wheel module.
Loosen the thumb screws for the prism module, and carefully slide the prism module out of
its mounting slots. Set the prism module aside for later reinstallation.
14