Advertisement
3
2
5
Figure 3
1. Blocker plate
2. Bolt, 3/8 x 5/8 inch
3. Flange nut, 3/8 inch
Installing the Cover Plate
1. Position the cover plate over the side discharge opening.
2. Secure the cover plate to the mower with 4 bolts (3/8 x
3/4 inch) and 4 flange nuts (3/8 inch) (Fig. 4).
1
2
Figure 4
1. Discharge cover plate
2. Bolt 3/8-16 x 3/4 inch
(19 mm)
3. Tighten all mounting hardware securely.
4
1
m–3925
4. Bolt, 1/4 x 5/8 inch
5. Flange nut, 1/4 inch
3
m–3926
3. Flange nut, 3/8 inch
Installing the Kickers
1. Measure from the spindle center lines, and locate
kickers as shown (Fig. 5). Position one kicker 7/16 inch
(11 mm) off to the right of the right spindle and one
kicker 1-7/8 inch (48 mm) off to the left of the left
spindle (Fig. 5).
2. Holding kickers tight against baffle, mark, center punch
and drill 2 holes (11/32 inch) holes for each kicker
(Fig. 5).
1 (right)
Figure 5
1. 7/16 inch (11 mm)
2. 1-7/8 inch (48 mm)
3. Place the kickers inside the mower over drilled holes
and install each kicker with 2 bolts (5/16 x 5/8 inch)
through from the bottom of the mower, and 2 flange
nuts (5/16 inch) (Fig. 6).
.
Figure 6
1. Kicker
2. Bolt, 5/16 x 5/8 inch
4. Tighten all mounting hardware securely.
3
2 (left)
3
3
m–3914
3. Mark, center punch and
drill 11/32 inch (9 mm)
holes
3
2
m–3927
1
3. Flange nut, 5/16 inch
Advertisement
