Chauvet Followspot 1200 Quick Start Manual page 9

Lamp
Installing a new lamp requires caution. Follow the steps indicated below to
complete the lamp installation in a safe manner.
Installation
If you touched the lamp with your bare hands, make sure to clean it
thoroughly (contacts, glass necks and glass globe) with isopropyl
alcohol and wipe it with a lint-free cloth before installing it.
Follow all the safety instructions indicated in pages 6 and 7.
Installing a
1) If installing a new lamp, open the Followspot 1200 as indicated in page 6.
New Lamp 2) Before installing the lamp, loosen its end screws.
3) Hold the lamp by its metallic contacts and slide it into the slots.
4) Ensure that the flat washers on the lamp shafts are on the thumbscrew
5) Evenly push the clips backward to allow the lamp to go all the way into
6) Rotate the lamp until the nipple is on the top of the bulb.
7) Tighten the lamp end screws.
8) Once installed, the lamp should look as in the diagram bellow.
Lamp Installation
Diagram
Closing the
1) Close the lamp cover and tighten the thumbscrew that holds it.
Fixture
2) Slide the front cover backward until it touches the bracket.
3) Tighten the thumbscrew to secure the front cover.
Followspot 1200 Quick Start Guide Rev. 3
All manuals and user guides at all-guides.com
side of the slot to ensure maximum contact.
the slots.
Flat
washer
Clip
Reflector
Clip
Lamp
end
screw
Setup
Lamp end
screw
Contact
plate
Bulb
nipple
Fixture's
front
Lamp
contact
Contact
plate
7