Chauvet Followspot 1200 Quick Start Manual page 7

Voltage &
The Followspot 1200 uses a single terminal strip to select the operating
voltage and frequency. This operation only requires connecting two wires to
Frequency
a terminal strip, as indicated below.
Do not connect the fixture to the power outlet without having selected
the voltage and frequency first. Make sure that the circuit's voltage
and frequency matches your selection to avoid unstable operation or
damage to the fixture.
Make sure that there is no power applied to the fixture before opening
the fixture's housing.
Opening the
1) Unfasten the thumbscrew (T) and slide the front cover (FC) slightly
Fixture
2) Unscrew the two Allen screws (A) and remove the bracket (B).
3) Carefully pick up and slide the back cover (BC) backward, making sure
Cover Removal
Diagram
Two black wires arrive to the terminal strip (TS). One wire labeled "1" and
the other labeled "2."
1) Connect the black wires as needed per the table below, without
2) Replace the covers.
3) Replace the bracket and secure it with the two Allen screws.
Voltage and
Frequency
Selection
Diagram
Followspot 1200 Quick Start Guide Rev. 3
All manuals and user guides at all-guides.com
forward.
not to pull the wires that run from its fans to the Fan Control PCB inside
the housing.
B
A
FC
T
reversing them.
BC
TS
Voltage/
Wire #1
Frequency
208 V, 50 Hz Terminal #2 Terminal #4
208 V, 60 Hz Terminal #2 Terminal #3
230 V, 50 Hz Terminal #1 Terminal #6
230 V, 60 Hz Terminal #1 Terminal #5
Setup
Wire #2
5