Dell Latitude 7330 Rugged Extreme Service Manual page 90

Steps
1. Connect the touch cable to its connector on the touch screen board.
2. Connect the eDP cable to its connector on the LCD module and flip the display bezel on the display assembly.
3. Align the display bezel with the display assembly. Gently snap the display bezel into place.
4. In sequential order, replace the 11 (M2.5x6, T8) screws that secure the display bezel to the display assembly.
NOTE: Ensure that the display assembly is placed on a flat surface when replacing the screws to avoid light leakage
from LCD. This must be done when part twisting assembly screw torque: 3 kgf-cm.
5. Replace the 4 (M2.5x6, T8) epoxy screws to secure the display bezel to the display assembly.
Next steps
1. Install the display assembly.
2. Install the system board.
3. Install the heat-sink (UMA).
4. Install the fan.
5. Install the smart card reader I/O
6. Install the smart card
7. Install the GPS board.
8. Install the inner frame.
9. Install the express card
10. Install the rear I/O board.
11. Install the dock I/O board.
12. Install the WWAN card.
13. Install the WLAN card.
14. Install the RF switch board.
15. Install the base cover.
16. Install the keyboard.
17. Install the primary M.2 2280 solid state drive
18. Install the battery.
19. Follow the procedure in
90 Removing and installing components
board.
reader.
reader.
or
after working inside your
primary M.2 2230 solid state
computer.
drive.