Dell Latitude 7330 Rugged Extreme Service Manual page 79

Steps
1. Place the left Type-C daughterboard on the system chassis.
2. Replace the (M2x3.5) and three (M2x5) screws that secure the left Type-C daughterboard to the system chassis.
3. Connect the daughterboard cable to its connector on the left Type-C daughterboard.
4. Connect the flat printed cable to its connector on the left Type-C daughterboard.
5. Replace the (M2x5) screw that secures the flat printed cable holder to the left Type-C daughterboard.
Next steps
1. Install the rear I/O board.
2. Install the dock I/O board.
3. Install the WWAN card.
4. Install the WLAN card.
5. Install the RF switch board.
6. Install the heat-sink (UMA).
7. Install the fan.
8. Install the base cover.
9. Install the keyboard.
10. Install the primary M.2 2280 solid state drive
11. Install the battery.
12. Follow the procedure in
or primary M.2 2230 solid state
after working inside your computer.
drive.
Removing and installing components 79