Steps
1. Align the inner frame with the screw holes on the system board.
2. Replace the four (M2x5) screws that secure the inner frame to the system board.
3. Route the WLAN, WWAN, and GPS antennas through their routing guides on the system chassis.
Next steps
1. Install the
GPS
board.
2. Install the
dock I/O
board.
3. Install the
WWAN
card.
4. Install the
WLAN
card.
5. Install the
RF switch
board.
6. Install the
base
cover.
7. Install the battery.
8. Install the
primary M.2 2280 solid state drive
9. Follow the procedure in
or
primary M.2 2230 solid state
after working inside your
computer.
drive.
Removing and installing components
59