Table of Contents
Advertisement
Condition/Problem
Resistance does not
change (machine turns on
and operates)
sleep mode) while in use
Unit rocks/does not sit
level
to pedal
Clicking sound when
pedaling
Seat post movement
Console continuously
cycles through program
screens
Things to Check
Check magnet position
Check Speed Sensor
Check data cable integrity
Check data cable
connections/orientation
Check Servo Motor
Check Console
Check electrical (wall)
outlet
Check connection at front
of unit
Check data cable integrity
Check data cable
connections/orientation
Reset machine
Check magnet position
Check Speed Sensor
Check leveler adjustment
Check surface under unit
Check pedal to crank arm
connection
Check pedal to crank arm
connection
Check locking pin
Check adjustment knob
Console is in demonstra-
tion mode
Magnet should be in place on pulley.
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
All wires in cable should be intact. If any are visibly pinched or
cut, replace cable.
Be sure cable is connected securely and oriented properly.
Reseat all connections. Small latch on connector should line up
and snap into place.
If magnets move, adjust until they are within the proper range.
Replace Servo Motor if not functioning properly.
Check for visual sign that Console is damaged. Replace Con-
sole if damaged.
If the above steps do not resolve the problem, contact Cus-
tomer Service (if inside US/Canada) or your local distributor (if
outside US/Canada) for further assistance.
Make sure unit is plugged into a functioning wall outlet.
Connection should be secure and undamaged. Replace
adapter or connection at unit if either are damaged.
All wires in the cable should be intact. If any are cut or pinched,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Magnet should be in place on pulley.
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Adjust levelers until bike is level.
even surfaces. Move bike to level area.
Pedal should be tightened securely to crank. Insure connection
is not cross-threaded.
Remove pedals. Make sure there is no debris on threads, and
reinstall the pedals.
Be sure adjustment pin is locked into one of the seat post
adjustment holes.
Be sure knob is securely tightened.
Press and hold the Schwinn
Sleep Mode.
Solution
™
logo button for 3 seconds. The
-
33
Advertisement
Table of Contents
