Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Technogym BIKE ARTIS
Summary of Contents for Technogym BIKE ARTIS
- Page 1 BIKE ARTIS ® USER MANUAL...
-
Page 2: Table Of Contents
Changing the fuses ................. 25 Technical characteristics ............... 13 Troubleshooting ..................26 Safety devices ..................14 Technical assistance ................27 Place of usage ..................15 Storing the product ................. 28 Moving the product ................. 16 Disposing of the product ................ 28 BIKE ARTIS... -
Page 3: Important Safety Instruction
Any other use should be considered incorrect and therefore dangerous. Do not use any accessories other than those recommended by Technogym. Never operate the product if it has a damaged cable or plug, if it is not working correctly, if it has been knocked over or damaged, or if it has fallen into water. In these circumstances, contact the Technogym Technical Support Service. - Page 4 To disconnect power, turn all controls to the off position, then remove the plug from the outlet. SAVE THESE INSTRUCTIONS Warnings Do not connect a device with load exceeding 7A. Risk of electric shock. Do not disconnect under load. Do not connect to a circuit operating at more than 150V to Ground. BIKE ARTIS...
-
Page 5: Personal Safety
Do not attempt any maintenance work on the product other than the operations described in the user manual. The installation, maintenance and setting operations must be carried out by qualified Technogym staff or persons authorised by Technogym. The electrical system must conform to the standards and legal requirements in the country of use. - Page 6 Technogym’s written authorisation or for failure on your part to use, operate and maintain the product as set out in this User Manual.
-
Page 7: Identification Of The Manufacturer And The Product
The values stated in the illustration are purely indicative; refer to the label attached to the product or the data in the “Technical characteristics” section for the correct information. Technogym S.p.A. via Calcinaro 2861, Cesena (FC) - Italy Made in Italy BIKE ARTIS Model no. -
Page 8: Description Of The Product
Display (A). It allows you to view and control information, settings and contents both for workouts and for entertainment. The tablet-style touch screen interface allows you to include the contents offered by the Technogym App Store. Object holder (B). Handlebar (C). For stability when getting on and off the bike; can also be held by the user during the workout. -
Page 9: Using The Product
On the saddle, lean your torso forwards, keeping your back straight, then rest your hands on the ends of the handlebar; your arms will be slightly bent. Warnings Avoid sideways movements. Pedal only when in a seated position on the saddle. BIKE ARTIS... - Page 10 (B) raised to loosen the strap. Bike is to be used solely for its intended purpose, i.e. as a cycle ergometer. Any other use of the product is to be considered improper and therefore dangerous. BIKE ARTIS...
-
Page 11: Using The Heart Rate Monitor
The heart rate shown on the display is purely indicative and cannot be considered absolutely certain. Do not use the heart rate monitor if you have a cardiac support device such as a pacemaker or similar. BIKE ARTIS... - Page 12 Combined use of fats and sugars. Significant improvement of aerobic efficiency. Prevalent use of fats and increased use of sugars. Moderate improvement of aerobic efficiency. Prevalent use of fats and little use of sugars. Limited improvement of aerobic efficiency. BIKE ARTIS...
-
Page 13: Technical Characteristics
0÷99.99 km ± 5% (0÷99.99 mls ± 5%) Protection grade IP 20 Electric isolation class Class I 1115 mm (44") 600 mm 1080 mm (24") (43") Adjustable braking system; power depends on the level set and speed. 1400 mm (55") BIKE ARTIS... -
Page 14: Safety Devices
Open panel (D) to reach the fuses: put a finger in the hole and pull. The label (E) provides electrical specifications and safety information. Warning Please read the adhesive labels on the product, which provide information about possible risks and hazards. BIKE ARTIS... -
Page 15: Place Of Usage
Do not use the product outside. Do not use the product outdoors, where it is exposed to the elements. Ensure that the product does not get splashed by water. Do not place the product in locations with high moisture levels, such as swimming pools, whirlpool tubs and saunas. Do not operate where aerosol (spray) products are being used or where oxygen is being administered. BIKE ARTIS... -
Page 16: Moving The Product
If wheels cannot be used on the floor, move the equipment with normal lifting and transport methods. After moving the product, always check it is level to safeguard correct operation. BIKE ARTIS... -
Page 17: Levelling
Adjust the feet as shown in the diagram in order to level the product. Loosen the lock nut (B). Screw the front feet (A) in or out until the frame is in a stable position. Tighten up the lock nut (B) after adjusting. BIKE ARTIS... -
Page 18: Electrical Connection
Check the state of the power supply cable periodically. Plug the power cable into the product socket first and then into the wall socket. Close panel (A) putting the cable through the slot. BIKE ARTIS... - Page 19 Do not modify the plug provided with the product; if it will not fit in the outlet, have a proper outlet installed by a qualified electrician. BIKE ARTIS...
-
Page 20: Other Connections
Use an RF coaxial cable to connect the antenna with an F-type connector for the product. The wall socket for the antenna cable must be located in a position where the plug can be inserted and removed with ease. BIKE ARTIS... -
Page 21: Turning On And Off
Warnings The switch turns the product on/off but it does not isolate it from the mains voltage, even if it is in position “0” (off). Take the power plug out of the socket to isolate the product. BIKE ARTIS... -
Page 22: Routine Maintenance
The safety of the product is assured only on the condition that it is carefully inspected every two weeks for any signs of damage and/or wear. Replace defective or worn components immediately, or remove the product from service. For maintenance actions not described in this manual, call in the Technogym Technical Service. BIKE ARTIS... - Page 23 Warnings The routine maintenance, adjustment and lubrication jobs must be performed by the Technogym Technical Support Service. Before servicing, turn off the product by moving the switch to the 0 position and take the power plug out of the socket.
-
Page 24: Adjusting The Play On The Saddle Support Tube
You are advised to check for play on the tube periodically, as it may cause vibrations and noise. Adjust the play by turning the two screws: undo the screw (A); turn the 2 screws (B) with an Allen wrench; check the play all the way along the saddle; re-tighten the screw (A). BIKE ARTIS... -
Page 25: Changing The Fuses
CHANGING THE FUSES Warnings The fuses must be changed by the Technogym Technical Support Service. Before making the replacement, turn off the product by moving the switch to the 0 position and take the power plug out of the wall socket. -
Page 26: Troubleshooting
Contact the Technogym Technical Support Service. The product is not turning ON The power supply cable is not correctly inserted Check the connection. To replace the blown fuse with a spare contact Technogym Burnt-out fuses Technical Support Service. The product is not level. -
Page 27: Technical Assistance
Via Calcinaro 2861, 47521 Cesena Italy on-site servicing tel: +39 0547 56047 supply of original spare parts. http://www.technogym.com/Support When you contact the Technogym Technical Support Service you must give the following information: Product model (A) Date of purchase Serial number (B) Technogym S.p.A. -
Page 28: Storing The Product
If the product is used for commercial purposes, contact your reseller or the Technogym Customer Service, in the various Countries, to arrange for collection and disposal of waste from electrical and electronic equipment. - Page 29 Bike Artis_en_AA 0SM01148...