Advertisement
NOTES:
1. The sensor type used in the last
print job is selected by default.
To change the sensor type, refer
to Section 2.8.1 Media Sensor
Calibration of the Owner's
Manual.
2. The Feed Gap Sensor is
positioned 6.27 mm right from
the media centre.
Feed Gap Sensor
6.27mm
NOTE:
Be careful not to squeeze the
media with the Media Guides.
Doing so bends the media, which
can cause a paper jam or feed
failure.
3. Pass the media through the Media Guides. Pull the media until it
reaches the front of the printer.
Media Guide
4. Check and select the sensor type to be used. (Refer to the
Owner's Manual.)
This printer has a Feed Gap Sensor which detects inter-label gaps.
As the Feed Gap Sensor position is fixed, it is not necessary to
adjust it.
E-9
Media Guide
Feed Gap Sensor
Advertisement
