VTech Toot-Toot Drivers Fix and Fuel Garage Instruction Manual page 7

If there are no locks inside the package, disregard this message.
Removing the Packaging Locks:
Turn the packaging locks anticlockwise
several times.
Pull out the packaging locks and discard.
INSTRUCTIONS
Battery Removal And
Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the Stock Car. Use a
screwdriver to loosen the screw and
then open the battery cover.
3. If used batteries are present,
remove from the unit by pulling up
on one end of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
6