12-Loop, Repeat And Single Playback; Loop Playback - Tascam DR-07 Owner's Manual

12–Loop, Repeat and Single Playback
In ordinary playback mode, once playback starts,
it will stop when the end of the last track in the
current playback area is reached (or you press the
key). By following the instructions
STOP/HOME
in this chapter, however, you can also make the
DR-07 loop a section of a track that you choose,
repeat the entire sequence of tracks in the current
playback area, play a single track repeatedly or
play a single track once and stop.

Loop playback

With this function, you can continuously repeat
(loop) the playback of a selection that you make.
1 Press the
I/O LOOP
set the point when you want to start loop
playback. The current position is set as
the IN point.
2 Press the
I/O LOOP
you want loop playback to stop. The current
position is set as the OUT point, and loop
74
TASCAM DR-07
key during playback to
key at the point when
playback begins between the IN and OUT
points.
The current positions of the IN and OUT points are
shown by the and
playback position display bar in the lower part of
the Home Screen. During loop playback the
indicator also appears.
To stop loop playback, press the
The loop playback area setting is also cleared at the
same time.
NOTE
Accurate assignment of IN and OUT points is
not always possible for variable bit rate (VBR)
MP3 files.
icons that appear below the
key.
I/O LOOP