About Scanning Configuration Barcodes; Use The Scan Demo App; Change The Scan Demo Symbology Settings - Honeywell CT45 Series User Manual

About Scanning Configuration Barcodes

After completing the out-of-box set up process, Provisioning mode is
automatically turned off. Scanning a barcode to install applications, certificates,
configuration files, and licenses on the computer is restricted unless you enable
Provisioning mode in the Settings app.
To learn more

Use the Scan Demo App

Use the Scan Demo app to read barcodes or to test your symbology decode
settings.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap the Demos app.
3. Swipe left or right on the screen until Scan Demo
4. Point the imager window at the barcode.
5. Press and hold either side Scan button or tap Scan
6. Center the aiming beam over the barcode. Make sure
.
7. Release the Scan button when the computer beeps and the Good Read LED
Note: In the Scan Demo app, not all barcode symbologies are enabled by default. If a
barcode does not scan, the correct symbology may not be enabled.

Change the Scan Demo Symbology Settings

1. In the Scan Demo app, tap in the upper right corner of the screen.
2. Select Symbology Settings.
3. Modify the symbology parameters.
4. Tap the Back arrow to return to the Scan Demo app.
46
About Provisioning
appears under the turntable. Tap the center of the
box image to open the app.
on the computer screen.
the entire barcode is inside of the illumination frame.
briefly turns on. Barcode information appears on the screen.
• Tap the check box next to a symbology name to enable (check mark) or
disable (no check mark) decoding for that symbology.
• Tap the symbology name to view and modify additional configuration
parameters for the symbology selected.
Mode, see page 83.
CT45/CT45 XP Mobile Computer Series User Guide