Scan Barcodes - Honeywell CT45 Series User Manual

4. Configure the button appearance. As you adjust the settings, the preview of the
5. Drag the preview of the Scan button to the location where you want it to appear
6. Tap Choose Application.
7. Check the box next to all the applications where you want the digital scan
8. Select OK.
9. Tap the Back arrow to return to the Settings screen.

Scan Barcodes

By default, the integrated imager is enabled for scanning. It supports
omni-directional (360°) barcode scanning and an aiming beam is provided to help
assist with targeting barcodes.
Before you start scanning barcodes, go into Settings
Scanning > Internal Scanner and modify the scan profile to enable only the
barcode symbologies that you need. By reducing the active symbology list, you can
increase scan speed.
1. Point the imager window at the barcode. For
2. Press and hold any Scan button.
3. Center the aiming beam over the barcode. Make sure
4. Release the Scan button when the computer beeps,
Note: Not all barcode symbologies are enabled by default. If a barcode does not scan, the
correct symbology may not be enabled.
CT45/CT45 XP Mobile Computer Series User Guide
button updates.
• Tap Select Button Size and then choose Small, Medium or Large.
• Tap Select Button Color and then choose from seven color options. Default
color is black. Tap a dot to select the color, and then select OK to confirm.
• Use the slider under Transparency Level to adjust how transparent the
button appears on the application screen.
on the screen. Once you have positioned the button, tap the Set Button
Location toggle button to lock it into position.
button to be available.
The digital scan button appears on the screen when you open any of the apps
you selected during the button setup. Tap and hold the button to activate the
imager and scan a barcode.
optimum performance, avoid reflections by
scanning the barcode at a slight angle.
the entire barcode is inside of the illumination frame.
and the Good Read LED briefly turns on. The
barcode information is entered into the application
in use.
> Honeywell Settings >
45