Troubleshooting - Bissell CLEANVIEW 3197 Series Manual

Troubleshooting

Below are some of the issues you may run into. If you don't see the issue you're experiencing
below, visit support.BISSELL.com.
Problem Possible Cause
Incorrect height
adjustment.
Hose not attached
properly.
Crack or hole in hose.
Broken or worn drive belt.
Rotating floor brush
Vacuum or
jammed.
tools won't pick
up dirt
Clog in vacuum.
Dirt tank full.
Dirt tank not installed
properly.
Filters are dirty.
Incorrect height
Vacuum is
adjustment.
difficult to push
Dirt tank full.
Visible dirt
escaping from
Filters missing or installed
vacuum
incorrectly.
Note: Any other servicing should be performed by an authorized service representative.
But wait, there's more!
Join us online for a complete guide to your new product, including
troubleshooting, product registration, parts and more.
REGISTER
We're Waggin' Our Tails!
BISSELL proudly supports BISSELL Pet Foundation® and its mission to
help save homeless pets. When you buy a BISSELL product, you help
save pets, too. We're proud to design products that help make pet
messes, odors and pet homelessness disappear.
Visit BISSELLsavespets.com to learn more.
Go to support.BISSELL.com.
INFO
©2021 BISSELL Inc. All rights reserved.
Part Number 1627947 06/21 RevC
Remedies
Adjust Powerfoot to correct height setting.
Grasp the hose wand and firmly push into the hose
wand base.
Check hose and replace if needed.
Replace drive belt, see page 7.
Remove brush and clean debris from brush ends,
see page 6.
Check for debris build-up or clogs in the inner tank,
hose and foot/lower hose. See online video for
more help.
Empty dirt tank.
Position correctly and lock in place, see page 5.
Check and clean pre-motor and post-motor filters,
see page 6. Replace pre-motor filter if needed.
Adjust Powerfoot to correct height setting, see
page 4.
Empty dirt tank.
Check and clean pre-motor and post-motor filters,
see page 6. Replace pre-motor filter if needed.
VIDEOS PARTS SUPPORT