Table of Contents
Advertisement
L. BLENDER POWER SWITCH (F131 Models Only)
The blender power switch is a two position toggle
switch used to supply power to the blender. When the
switch is in the OFF position, the agitator will not turn.
When the switch is in the ON position, the agitator
will be activated every time the blender activation
switch is pressed.
M. BLENDER ACTIVATION SWITCH
(F131 Models Only)
The blender activation switch is a two speed, momen
tary contact switch that will actuate the agitator to
blend product when pressed in and held in either the
HIGH or LOW speed position. The HIGH speed
position is used to blend fruit into dairy mix when
making smoothies. The LOW speed position is used
during cleaning procedures.
3.3 SANITIZING
Sanitizing must be done after the freezer is clean and
just before the hopper is filled with mix. Sanitizing the
night before is not effective. However, you should
always clean the freezer and parts after using it.
THE UNITED STATES DEPARTMENT OF AGRICUL-
TURE AND THE FOOD AND DRUG ADMINISTRATION
REQUIRE THAT ALL CLEANING AND SANITIZING SO-
LUTIONS USED WITH FOOD PROCESSING EQUIP-
MENT BE CERTIFIED FOR THIS USE.
When sanitizing the freezer, refer to local sanitary
regulations for applicable codes and recommended
sanitizing products and procedures. The frequency of
sanitizing must comply with local health regulations.
Mix sanitizer according to manufacturer's instructions to
provide a 100 parts per million strength solution. Mix
sanitizer in quantities of no less than 2 gallons (7.5
liters) of 120°F of water. Allow sanitizer to contact the
surfaces to be sanitized for 5 minutes. Any sanitizer
must be used only in accordance with the
manufacturer's instructions.
CAUTION
Do not allow sanitizer to remain in contact with
stainless steel freezer parts for prolonged
periods. Prolonged contact of sanitizer with freezer
may cause corrosion of stainless steel parts.
In general, sanitizing may be conducted as follows:
A. Push the mix inlet regulator into hopper with air inlet
(long) tube toward the front of the freezer.
(Fig. 10).
Figure 10. Mix Inlet Regulator
B. Prepare 2 gallons (7.5 liters) of sanitizing solution
following manufacturer's instructions. Pour into
hopper with mix inlet regulator in place (Fig. 11).
Figure 11. Sanitizing Procedure
C. Place the OFF-ON toggle switch in the ON position
while pressing the CLEAN switch. Check for leaks.
(Fig. 12)
Figure 12. Clean Control
9
Advertisement
Table of Contents
