Sony VPL-VW1000ES Operating Instructions Manual page 68

Symptom
Image is left on the screen.
(image retention)
On-screen display
Symptom
On-screen display does not
appear.
The model name does not
disappear from the screen.
Input terminals do not
appear.
Remote control
Symptom
The remote control does
not work.
68
Cause and Remedy
c When high contrast non-moving images are displayed for a long
period of time, there may be some image retention on the
screen. This is only a temporary condition. Turning off the
power for a while will eliminate the retained image.
Cause and Remedy
c Set "Status" on the Setup
c Check if the ON/STANDBY indicator should light in green.
When the ON/STANDBY indicator blinks in green, the unit is
starting up. Wait until it stops blinking and remains lit in green.
c The display mode of the unit may be set at the time of purchase.
Consult with your local dealer or qualified Sony personnel.
c Set "Auto Input Search" on the Function
page 54).
Cause and Remedy
c Batteries could be weak. Replace them with new batteries
(1 page 11).
c Insert the batteries with the correct polarities (1 page 11).
c If there is a fluorescent lamp near the remote control detector,
the unit may work improperly or inadvertently.
c If you use the optional 3D Sync Transmitter and point it to the
remote control detector of the unit, the remote control may not
work properly.
c Confirm the position of the remote control detector on the unit
(1 page 8).
c Set "IR Receiver" to "Front & Rear" on the Installation
menu (1 page 55).
menu to "On" (1 page 50).
menu to "Off" (1