Using The E-Mail Report Function - Sony VPL-VW1000ES Operating Instructions Manual

Using the E-mail Report
Function
Set the e-mail report function on the Setup
page.
Entered values will not be applied unless
you click on [Apply].
1
Click on [Owner information] to
enter the owner information
recorded in the
Owner information button
2
Set the timing of the e-mail
report.
Click on [Mail Report] to open the Mail
Report page.
Lamp Reminder (Lamp1): Set the
timing for lamp replacement. To reset
Lamp Reminder, execute "Lamp
Setting" on the unit (1 page 51).
Maintenance Reminder: Set the timing
for maintenance. To reset
Maintenance Reminder, check the
RESET check box and then click on
[Apply].
e-mail report.
1
Mail Report button
2
3
4
6
5
3
Enter the outgoing e-mail
address in the Email Address
box, then check the Report
Timing check box of the e-mail
report to be sent.
4
Set the mail account for sending
e-mail reports.
Mail Address: Enter the e-mail address.
Outgoing Mail Server (SMTP): Enter
the address of outgoing mail server
(SMTP).
Required Authentication: Check this
check box if authentication is required
for sending e-mail.
Requires the use of POP
Authentication before send email
(POP before SMTP): Check this
check box to arrange for POP
authentication to be performed before
sending e-mail.
Incoming Mail Server (POP3): Enter
the address of the incoming-mail
server (POP3) to be used for POP
authentication.
Account Name: Enter the mail account.
Password: Enter the password.
63