Skil PWRCORE 20 HD6294B-00 Owner's Manual page 15

To remove the bit:
a. Rotate the chuck body counterclockwise, as viewed from the chuck end, to open the chuck.
b. Remove the bit.
Fig . 8a
Unlock ("OPEN")
WARNING
chuck jaws . Do not insert the drill bit into
the chuck jaws at an angle and then tighten
the chuck as shown in Fig . 8b . This could
cause the drill bit to be thrown from the tool,
resulting in possibly serious personal injury or
damage to the chuck.
WARNING
protective gloves when removing the bit
from the tool, or first allow the bit to cool down .
Removable Belt Clip (Fig. 9)
Your tool is shipped with a removable belt clip
that can be positioned on the either side of the
tool for convenient transportation.
To install the belt clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the rib and the hole of the belt clip with
the opening and the threaded hole on the
base of the tool, respectively.
c. Insert the screw and securely tighten the
screw with a screwdriver (not included).
To remove the belt clip from the tool:
a. Remove the battery pack from the tool.
b. Use a screwdriver (not included) to loosen the screw that attaches the belt clip to the tool.
c. Remove the screw and the belt clip. Keep them in a safe place for future use.
Make sure to insert the
drill bit straight into the
The bit may be hot after
prolonged use . Use
Lock ("CLOSE")
Fig . 8b
Fig . 9
Removable
Belt Clip
Opening
Rib
15