Skil PWRCORE 20 HD6294B-00 Owner's Manual page 12

Direction-of-Rotation (Forward/Center-Lock/Reverse) Selector (Fig. 3)
WARNING
Your tool is equipped with a direction-of-rotation selector, located above the trigger switch. This
selector is designed for changing the direction of rotation of the bit and for locking the trigger in
the "OFF" (center-lock) position.
a. Position the direction-of-rotation selector to the far left of the tool to drill holes or drive the
screws in.
b. Position the direction-of-rotation selector to the far right of the tool to remove screws.
c. Position the switch in the "OFF" (center-lock) position to help reduce the possibility of
accidental starting when the tool is not in use.
NOTICE: To prevent gear damage, always allow the hammer drill to come to a complete stop
before changing the direction of rotation.
NOTE: The hammer drill will not run unless the direction-of-rotation selector is engaged fully to
the left or the right.
Fig . 3
Variable-Speed Trigger Switch
(Fig. 4)
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the variable-
speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
12
After tool use, lock the direction-of-rotation selector in the "OFF"
position (center-lock) to help prevent accidental starts and possible injury .
Forward Center-Lock
Fig . 4
Variable-Speed
Trigger Switch
Reverse